US Flag Patch

$4.99

Category:

Description

American Flag with Gold Border & Heat Seal Backing is ready to be sewn or fused with an iron or heat press (350 degrees at 20-25 seconds).  It should be worn above the left breast pocket and with the bottom of the patch ¾ inches above that pocket.

 

Instructions for Ironing:

  1. Wash fabric first. Fabric softener should not be used.
  2. Set iron to cotton setting. Do not use steam, and remove water from iron.
  3. Lay your garment out on a hard, heat tolerant surface. A padded ironing board is not hard enough. Try placing a cutting board above padding.
  4. Place heat seal side of patch onto fabric in desired placement area (above the left breast pocket and with the bottom of the patch ¾ inches above that pocket). Iron design for approximately 30-60 seconds, applying pressure. Do not move iron side to side as this may cause the design to shift. Heavier fabrics may require more time, and lighter fabrics may require less time.
  5.  Allow time to cool, then make sure the entire surface area is applied to the fabric. If all pieces did not adhere, reapply heat for an additional 20-30 seconds. Allow to cool.
  6. Turn the garment inside out and apply the iron to the back of the design area for approximately 30 seconds. Wait 48 hours before washing, and turn the garment inside out when doing so.

Reviews

There are no reviews yet.

Be the first to review “US Flag Patch”

Your email address will not be published. Required fields are marked *